Aluminum chemical polishing agent YG-D601
- Product introduction: This product is suitable for chemical polishing of pure aluminum and aluminum alloy (except cast aluminum), which can rapidly improve the glossiness of aluminum workpiece surface and achieve mirror brightness. The product also has th...
- Consultation hotline：13711993170
-
Product details
Product introduction: This product is suitable for chemical polishing of pure aluminum and aluminum alloy (except cast aluminum), which can rapidly improve the glossiness of aluminum workpiece surface and achieve mirror brightness. The product also has the function of deburring.
Product index: specific gravity: 1.2~1.22
Operation process flow:
① First, prepare a steel and stainless steel polishing container, pour the aluminum deburring and polishing agent solution into the polishing container, fully stir it with plastic rods and tools, and heat the polishing solution to 80 ℃~100 ℃ with a stainless steel heating tube.
② Use operating tools (clamps, hooks, etc.) to gently put the aluminum workpiece without oil, dirt, ink and words into the polishing solution at 80 ℃~100 ℃, gently turn the workpiece, and when the reaction of aluminum workpiece is accelerated (about 1 minute), immediately take the workpiece out and put it into the cleaning pool for cleaning.
③ Ash removal and passivation: there is a layer of black ash on the surface of the polished aluminum workpiece, which can be wiped off with a towel, or soaked in the ash removal and passivation agent for 3~5 minutes, and then the workpiece can be taken out and cleaned with water god.
④ When drying or drying the workpieces, pay attention not to overlap the workpieces. We should open up wrongly.
matters needing attention:
1. The product is corrosive, and you should wear latex gloves for operation (large process or assembly line operation, and you should wear a helmet and latex gloves for operation).
2. The surface of aluminum workpiece shall be free of oil stain, ink words, adhesive tape, etc. before polishing.
3. Since a large amount of water vapor is generated during high-temperature polishing, an exhaust fan shall be set beside the polishing container.
4. During the polishing process, aluminum workpieces shall be taken and placed with operating tools, not by hand, to prevent scalding. Other aluminum treatment, spraying copper polishing agent, etc
Label：
Previous：none
